KROHNE CORIMASS G-MFM 4085 EN User Manual

Page 2

How to use these installation and operating instructions

For easy reference these Instructions are divided into four parts.

Only Part A (page 3) is needed for installation and initial start-up.

All CORIMASS mass flowmeters of the G-Series are factory set to your order specifications.

Part A

Install flowmeter in the pipeline (Sect. 1), connect up (Sect. 2) and power the
flowmeter (Sect. 3).

The system is operational

Part B

Operator control and functions of the MFC 085 Signal Converter.

Part C

Service and functional checks.

Part D

Technical data, dimensions and measuring principle.

Product liability and warranty

The CORIMASS mass flowmeter MFM 4085 is designed for the direct measurement of mass
flow rate, product density and product temperature, and also indirectly enables measurement of
parameters such as total mass, concentration of dissolved substances and the volume flow.

For use in hazardous areas, special codes and regulations are applicable which are specified
in the special ”Ex installation and operating instructions” (supplied only with hazardous-duty
equipment).

Responsibility as to suitability and intended use of our instruments rests solely with the
purchaser.

Improper installation and operation of the flowmeters may lead to loss of warranty.

In addition, the ”general conditions of sale” forming the basis of the purchase agreement are
applicable.

If you need to return CORIMASS flowmeters to KROHNE, please complete the form on the last
page of this manual and return it with the meter to be repaired. Krohne regrets that it cannot
repair or check your flowmeter unless accompanied by this completed form.

CE / EMC Standards / Approvals

•

The Corimass MFM 4085 with the MFC 085 signal converter meet the requirements of the

EU-EMC Directives and bear the CE symbol.

•

The Corimass MFM 4085 K -Ex are approved as hazardous duty equipment to the

harmonised European Standards and to Factory Mutual (FM). Further details are given in the
”Ex” supplementary instructions provided only with hazardous-duty equipment.

Technical data subject to change without notice