Triton 9610 Operation Manual - Manual (Page 30)

SECTION 3 - INITIAL SETUP OPERATION MANUAL - MODEL 9610
3-2 TRITON SYSTEMS, INC.
Initial Setup Parameters
There are a number of configuration parameters that must be set
when a Cash Dispenser is installed. These parameters do not need
to be set in any particular order, but they MUST be entered into the
Cash Dispenser to enable customer transactions to take place.
Once they are set, they are retained internally, even when the Cash
Dispenser is turned off.
Detailed procedures describing the step-by-step setup of each ter-
minal parameter are located in Section 5 of this manual.
Terminal Number
The Terminal Number is a unique string of alphanumeric charac-
ters (numbers and/or letters) that identifies your Cash Dispenser
to the processor. The Terminal Number is assigned to your Cash
Dispenser by your processor
The Terminal Number and TELEPHONE NUMBER MUST be set
before the Cash Dispenser can go on-line and before the commu-
nications key can be downloaded.
Telephone Number
The Cash Dispenser communicates to your host processor over a
dial up phone line. The phone number of the processor must be
entered before live transactions can be performed.
Surcharge Mode
Some networks allow a surcharge, or terminal fee, to be imposed
on withdrawal transactions. If surcharges are in use on your net-
work, you are required to notify the customer of the possibility of
an additional fee before the transaction is processed. The cus-
tomer must be given a chance to cancel the transaction.
Setting the SURCHARGE MODE to ENABLED will cause the sur-
charge warning screen to be displayed after the customer’s card is
inserted. The surcharge warning screen notifies the customer of a
possible fee and its amount. The customer is given the opportu-
nity to cancel the transaction at no charge or to accept the sur-
charge and continue with the transaction.
If your network does not allow surcharges, the SURCHARGE
MODE must be set to DISABLED.