Triton 9610 Operation Manual - Manual (Page 103)

TRITON SYSTEMS, INC. 5-61
OPERATION MANUAL - MODEL 9610 SECTION 5 - MANAGEMENT FUNCTIONS
F
UNCTION
: SURCHARGE PERCENT
F
ACTORY
D
EFAULT
: N/A
A CCESS I NSTRUCTIONS :
1.) Select TERMINAL CONFIGURATION from the
MANAGEMENT FUNCTIONS menu.
2.) Select SET TERMINAL PARAMETERS.
3.) Choose the SURCHARGE MODE option.
4.) Select SURCHARGE PERCENT.
D ESCRIPTION :
The SURCHARGE PERCENT option on the SURCHARGE MODE
screen brings up the PERCENT SETTINGS screen, which enables
you to enter a surcharge percentage amount, as well as choose
the LESSER or GREATER option that is applicable to the surcharge.
Remember that these options must conform to the processor’s
requirements or other applicable commerce regulations.
To enter a surcharge percent value press the CHANGE PERCENT
AMOUNT key. the ENTER NEW AMOUNT AND PRESS OK prompt
replaces the CURRENT PERCENT IS: field. Enter the applicable
percentage value (from 1 and 99 percent) and press “OK”.
If the processor or other authority requires that the surcharge be
the lesser of either the surcharge amount or surcharge percent-
age, select the LESSER option. If the surcharge must be the greater
of either the surcharge amount or surcharge percentage, select
the GREATER option.
This value is stored in the terminal and will be displayed to the
customer on the applicable surcharge message screen. The per-
cent settings must be correct to ensure surchargfe messages
CUSTOM-G and CUSTOM-H are accurate!
E
RROR
C
ONDITIONS
:
If a fixed surcharge amount is to be used (surcharge percent not
used) you must ensure the surcharge comparison option is set to
GREATER and the surcharge percent is set to zero (0). This will
ensure that only the fixed surcharge amount value will be displayed
to the customer. Failure to do so can cause an incorrect surcharge
value to be reported to the customer.