Triton 9610 Operation Manual - Manual (Page 176)

TRITON SYSTEMS, INC.
SECTION 6 - MAINTENANCE OPERATION MANUAL - MODEL 9610
6-4
\
3. Push the paper spool (or partial roll of paper) from its location
in Figure 6-3A to the position shown in Figure 6-3B.
4. Remove the paper spool from the paper support bracket by
pulling the slotted small end of the spool out of bracket.
5. Remove the tab securing the end of the new paper roll to itself.
Use scissors to cut off all of the paper up to and including the
glue tab. Insert the paper spool into the new roll of paper (as
shown in Figures 6-4A and 6-4B). Use a 6-inch roll of 60-mm
wide thermal paper. Be sure the paper spool is inserted so that
the paper will feed from the top of the roll when it is installed on
the paper bracket.
6. Place the paper roll and paper spool back on the paper bracket
by sliding the small slotted end of the spool into the large hole
in the bracket as shown in Figure 6-5A. Push the paper and
spool into the operating position to lock them in place as seen
in Figure 6-5B.
7. Once the paper roll and spool are installed on the paper bracket,
take the end of paper roll and feed it into the printer path paper
entrance, as shown in Figure 6-6.
8. Once the paper is fed into the paper path entrance, the printer
will activate and automatically feed the paper through the printer
and out the exit. See Figure 6-7.
9. Close and lock the Cash Dispenser.
Figure 6-7. A new roll of paper
installed on the Printer.
Figure 6-6. Feeding paper into the
printer.
Figure 6-5B. Paper roll and spool
in place for operation.
WARNING
Do not pull the paper backward through the printer.
This may leave paper fragments that can cause paper
jams.