Hired-Hand Mega-Cool rev 6-09 - Manual (Page 32)

Part No. 4801-5120 Rev. 6-09 Mega-Cool System Page 32
5
Mega-Cool 10'-80' Straight, End-Mount Sump
Pump
INSTRUCTIONS - Tee-Tank Assembly
1. The PVC for the Tee-Tank Assembly is precut to length.
Assemble the Tee-Tank in the order shown at the left.
2. Glue Bottom Cap (Item #1) to 12"x3' Reservoir Pipe (Item #2)
as shown at the left.
3. Glue Reservoir Pipe (Item #2) into the bottom of Tee (Item
#3). Then glue the Slotted Pipe (Item # 4) into the top of the Tee
(Item #3). Make sure to align the slot in Item #4 with the
extended center of Tee (Item #3) as shown at the left.
4. Glue the 8"x22 ½° Elbow (Item #6) onto the 8"x2' Pipe (Item
#5). Then glue opposite end of the Elbow (Item #6) onto the 8"
system Reservoir Pipe (Item #7) as shown at the left. Make sure
the 8"x2' Pipe (Item #5) is level during assembly and is angled
away from wall.
5. Glue Tee-Tank assembly (Items # 1, 2, 3 & 4) onto 8”x2’ pipe
(Item #5) as shown at the left. Bottom part of Tee-Tank
assembly must be installed below ground level as shown below.
‘
Drain
Valve
Submersible Pump
Ground Level
Sump Pump Installed
below Ground Level
IMPORTANT!
Install Filter with
arrow pointing in
direction of water
flow!
DO NOT GLUE, Top must be
removed to service pump.
Threaded Union
Threaded
Union
1
2
3
4
6
Sump Pump Front View
7
Elbow
NOTE: Refer to Page
32 for pump
assembly and
spray line
connections.
NOTE: The Pump housing is designed to be installed below ground level.