Hired-Hand Mega-Cool rev 6-09 - Manual (Page 20)

Part No. 4801-5120 Rev. 6-09 Mega-Cool System Page 20
4” and 6” PAD:
Assemble Left Hand and Right Hand Top
and Bottom System End Cap Sections
together using ¼-20x1/2" stainless steel
bolts and ¼-20 stainless steel nuts
provided as shown above to the desired
height.
NOTE: Top Section without bottom section
used for 3 ft. high pads.
System End Cap assembly:
Top holes in top section adjust height for 4
ft. pads.
Second set of holes from the 4 ft. holes
adjust height for 5 ft. pads.
Third set of holes from the 4 ft. holes
adjust height for 6 ft. pads.
Bottom set of holes adjust height for 2
meter pads.
4 ft. Pads
5 ft. Pads
6 ft. Pads
2 meter Pads
Top Section
Top Section
Bottom Section
Bottom Section
NOTE: Illustration
shows lineup for 5
ft. Pads.
¼-20x1/2"
Stainless
Steel Bolts
¼-20x1/2"
Stainless
Steel Bolts
¼-20
Stainless
Steel Nuts
¼-20
Stainless
Steel Nuts
#10x 1” TEK
Screws
Assemble End Caps
Assemble Top Section to
Inside of System End
Right End Cap
Left End Cap