2 the bit structure of the status information, Status information 1, Status information 2 – Yokogawa µR20000 User Manual
Page 92: Status information 3, Status information 4, 2 the bit structure of the status information -2
6-2
IM 04P01B01-17E
6.2 The Bit Structure of the Status Information
The following four groups of status information are output in response to a status
information output request using the IS command. For the output format, see “Status
Information” in section 5.2, “Output Format of ASCII Data.”
Status Information 1
Bit
Name
Description
0
A/D conversion complete
Set to “1” when the A/D conversion of the
measurement is complete.
1
–
–
2
Periodic printout timeout
Set to “1” when the periodic printout timer expires.
3
TLOG timeout
Set to “1” when the TLOG timer expires.
4
–
–
5
–
–
6
–
–
7
–
–
Status Information 2
Bit
Name
Description
0
Measurement drop
Set to “1” when the measurement process could not
keep up.
1
Decimal point/unit
Set to “1” when the decimal point/unit information is
information change
changed.
2
Command error
Set to “1” when there is a command syntax error.
3
Execution error
Set to “1” when an error occurs during command
execution.
4
–
–
5
–
–
6
–
–
7
–
–
Status Information 3
Bit
Name
Description
0
–
–
1
Chart end
Set to “1” while the recorder is out of chart paper.
2
–
–
3
–
–
4
–
–
5
Chart feeding
Set to “1” while the chart is being fed through the
panel key.
6
–
–
7
–
–
Status Information 4
Bit
Name
Description
0
Basic setting
Set to “1” during Basic Setting mode.
1
Recording
Set to “1” while recording is in progress.
2
Computing
Set to “1” while computation is in progress.
3
Alarm generating
Set to “1” while the alarm is occurring.
4
–
–
5
–
–
6
Header printing out
Set to “1” only between start of Start printout and end
of End printout.
7
–
–