Yokogawa Button Operated MV2000 - Manual (Page 149)

5-30
IM MV1000-17E
Configured Channel Information Data
• The MV returns the configured channel information data in response to an FE5
command.
• The ID number of the output format is 25.
• You can use the CB command to specify whether or not the MV will return data of
measurement channels set to skip and computation channels set to OFF.
• The figure below indicates the format.
Number of blocks Block size
Configured channel information block 1
...
Configured channel information block n
(Reserved) (Reserved)
2 bytes 1 byte 1 byte 1 byte 1 byte
Version (Reserved)
2 bytes
Format Details
Item Description Output Value
Version Format version 1
Number of blocks * Number of configured channel information blocks Up to 348
Block size * Size of the of configured channel information blocks 72
Block 1 to n Configured channel information blocks Up to 25056 bytes
See Block Details.
* Returned in the byte order specified by the BO command.
Block Details
Item Number of Bytes Description
Channel number * 2 1 to 440
Decimal place 1 0 to 4
(Reserved) 1 0
Channel type * 4 2H for measurement and external input channels
and 4H for computation channels.
This value is ORed with 800H when the range mode
is DI or 8000H when the range mode is skip.
Unit information 8 The terminator is ‘\0.’
Tag information 24 The terminator is ‘\0.’
Minimum input value * 4 Measurement channels: Allowable input range under
the current setting
Maximum input value * 4 Computation channels: –9999999, +99999999
(fixed)
External input channels: –30000, +30000 (fixed)
Span lower limit * 4 Measurement channels (when scaling is not used):
Same value as the MV span setting
Span upper limit * 4 Measurement channels (when scaling is used):
Same value as the MV scale setting
Computation and external input channels:
Same value as the MV span setting
Scale lower limit * 4 Measurement channels:
Same value as the span
Scale upper limit * 4 Computation and external input channels:
Same value as the span
FIFO type * 2 1
Area in the FIFO * 2 Indicates the position of its own channel in the FIFO
block of one sample.
The value starts from zero.
(Reserved) 4 0
* Returned in the byte order specified by the BO command.
5.3 Binary Data Output Format