Watlow Series 96 - Manual (Page 54)

7 . 2 ■ R a m p i n g Wa t l o w S e r i e s 9 6
Active if hardware is present for
Outputs 2, 3 or 4 and the pa-
rameters are set to [Eunt]
.
Selecting a number to appear will
turn the respective event out-
put on during the program
step.
See p. 7.7 [`Off] (0) [`Off] (0)
[```2] (1)
[```3] (2)
[`2`3} (3)
[```4]
****
[`2`4} ****
[`3`4} ****
[`234] ****
[Eout] Event Outputs
Selects whether the
event output(s) are
on or off during the
program step.
Active if the value set for [ptyp]
is [rate] or rate based profile.
See p. 7.7 [``)O] [``)O] to [36)0] °F
[``)O] to [20)0] °C
[``)O] to [36)0] Units [rate] Rate
Indicates rate at
which the set point
changes in degrees
per minute.
Active if the value set for [ptyp]
is [``ti] or time based profile.
See p. 7.7 [```O] [```O] to [``59] [`SeC] Seconds
The number of sec-
onds, (plus Hour and
Min parameters)
equal the total step
time to achieve the
ending set point
under the [styp]
step type.
Active if the value set for [ptyp]
is [``ti] or time based profile.
See p. 7.7 [```O] [```O] to [``59] [min] Minutes
The number of min-
utes, (plus Hour and
Sec parameters)
equal the total step
time to achieve the
ending set point
under the [styp]
step type.
Active if the value set for [ptyp]
is [``ti] or time based profile.
See p. 7.7 [```O] [```O] to [``99] [Hour] Hour
The number of
hours, (plus Min and
Sec parameters)
equal the total step
time to achieve the
ending set point
under the [styp]
step type.
Active: Always See p. 7.7 75°F/24°C or
[``rl]
value if
[``rl]
≥
75°F/24°C
or if
[``rH]
≤
75°F/24°C
[`Off] (-32768)
[`rl1]
[`rH1] [``sp] Set Point
Indicates ending set
point value the con-
troller ramps to dur-
ing the set point
step.
[stpt] Set Point Step
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Register Parameters to Appear
read/write
**** Output 4 parameters cannot be changed with the Modbus interface.