Watlow Series 96 - Manual (Page 49)

Active: Always 1301 r/w [chng] (1) [hide] hide (0)
[chng] change (1)
[read] read only (2) [Oper] Operations Page
Mode Lock
Set the Operations
Page lockout level.
Active: Always, unless ramping
version of the controller is se-
lected (96__-____-AA__).
1304 r/w [chng] (1) [hide] hide (0)
[chng] change (1)
[read] read only (2) [CUSt] Custom Menu
Lock**
Set the Custom
Menu lockout level.
Active: Always 1300 r/w [chng] (1) [chng] change (1)
[read] read only (2) [``Sp] Set Point Lock
Set the set point
lockout level.
[`LOC] Lockout Menu
[Fcty] Factory Page
[tsht] Troubleshooting must
be set to [`pid] PID.
[tsht] Troubleshooting must
be set to [`pid] PID.
[tsht] Troubleshooting must
be set to [`pid] PID.
[rE`2] Reset 2 (22)
[rA`2] Rate 2 (23)
[Ct`2] Cycle Time 2
(24)
[db`2] Dead Band 2
(25)
[a2hi] Alarm 2 High
(26)
[A2Lo] Alarm 2 Low
(27)
[a3hi] Alarm 3 High
(28)
[a3Lo] Alarm 3 Low
(29)
[a4hi] Alarm 4 High
[a4Lo] Alarm 4 Low
[P``t] Proportional
Term (32)
[I``t] Integral Term
(33)
[d``t] Derivative
Term (34)
[hYS1] Hysteresis 1
(35)
[hYS2] Hysteresis 2
(36)
[AhY2] Alarm Hystere-
sis 2 (37)
[AhY3] Alarm Hystere-
sis 3 (38)
[AhY4] Alarm Hystere-
sis 4
[SP`1] Set Point 1 (40)
Wa t l o w S e r i e s 9 6 P a r a m e t e r s ■ 6 . 1 9
Setup Page / Lockout Menu
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Register Parameters to Appear
read/write
NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.