Watlow Series 96 - Manual (Page 52)

NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.
NOTE: Complete calibration menus and parameters are explained at Watlow’s web site,
http://www.watlow.com/literature/prodtechinfo. Search on 96 calibration manual.
Active if Calibration Lock (Lock-
out Menu) is not set to [hide].
1602 w [``no] (0) [``no] no (0)
[`yes] yes (800)
[dflt] Default Settings
Restore default set-
tings.
Active if Calibration Lock (Lock-
out Menu) is not set to [hide].
1601 w [``no] (0) [``no] no (0)
[`yes] yes (1) [`rSt] Restore Factory
Calibration
Restore factory cali-
bration. Does not af-
fect operations and
setup parameters.
[cin1] Calibration 1 Menu Enter [dIag] mode (1789) 1512 w
[Fcty] Factory Page Enter [cin1] mode (1415) 1600 w
Active: Always
(Model 96A - available only with
ac input.)
1515 r none [line] Line Frequency
Displays the AC line
frequency in Hz.
Proportional term 205
Integral term 206
Derivative term 207 [`Pid] [``no]
[`Pid] enables PID
terms in custom
menu
[Com] sends modbus
packet every 1 sec-
ond
[TShT] Troubleshooting
Helps solve prob-
lems with the con-
troller.
Active: Always 1505 r none [cnt2] Channel 2 A-D
Counts
Displays the raw
channel 2 A-D
counts.
Active: Always 1504 r none [cnt1] Channel 1 A-D
Counts
Displays the raw
channel 1 A-D
counts.
Active: Always 1501 r none [Acnt] Ambient A-D
Counts
Displays the raw
ambient channel A-
D counts.
Active: Always 1500 r none [amb] Ambient
Temperature
Read the ambient
temperature in 0.1
degrees Fahrenheit.
6 . 2 2 ■ P a r a m e t e r s Wa t l o w S e r i e s 9 6
Factor
y Page / Calibration 1 Menu
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Register Parameters to Appear
read/write