Watlow Series 96 - Manual (Page 53)

Wa t l o w S e r i e s 9 6 R a m p i n g ■ 7 . 1
Chapter Seven
Ramping
7
Program Menu Prompts
Entering the Program Menu: Press the ‰Advance key to enter the Program Menu while
the program is on hold or not running.
Figure 7.1 – The Program Menu
Note: The Program Menu will only appear if the ramping software option has been ordered (96 _ _ - _ _ _ _ - AA _ _ ) .
See p. 7.7 [`end] (3) [stpt] Set Point (0)
[soaH] Soak (1)
[``jl] Jump Loop (2)
[`end] End (3) [styp] Step Type
Select from four dif-
ferent step types.
[```1] (1) [```1] (1 to 8)
to
[```8]
[step] Step
Represents the cur-
rent step of the pro-
file to be edited or
viewed.
[```1] (1) [```1] (1 to 2)
[```2] [file] File
Represents the pro-
file to be edited or
viewed.
Active if hardware is present for
Outputs 2, 3, or 4 and the pa-
rameters are set to [Eunt]
.
Selecting a number to appear will
turn the respective event out-
put on.
1268 r/w [`Off] (0) [`Off] (0)
[```2] (1)
[```3] (2)
[`2`3} (3) [Eunt] Event Outputs
Manually change the
event output status
while the program is
not running.
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Register Parameters to Appear
read/write
[File] File
[step} Step
[Styp} Step Type
[Stpt] Set Point Step [soaH] Soak Step [``JL] Jump Loop Step [`EnD] End Step (End)
[``SP] Set Point [Hour] Hour [``JF] Jump File [`EnD] Select End Type
[Hour] Hour [min] Minutes [``JS] Jump Step
[min] Minutes [`seC] Seconds [``JC] Jump Count
[`seC] Seconds [eout] Event Outputs
[rate] Rate [`we} Wait-for Event Input v
[eout] Event Outputs [wde} Wait-for Deviation Value
[eunt] Event Outputs