Watlow MINICHEF Deep Fat Fryer Application - Manual (Page 84)

8 2 ■ Wa t l o w M I N I C H E F 2 0 0 0 A p p l i c a t i o n 1 7
With Sound set to 4 or 5, [``End] will appear on the display and the menu key
indicator light will flash rapidly. You must acknowledge the audible tone by pressing
the active menu key. Once acknowledged, the tone is silenced and the controller
goes into idle.
4. Remove the food from the fryer. The controller will continue to regulate to the set
point. The menu key indicator light will be off.
5. To repeat cooking, repeat steps 1 through 4.
Cancel a Menu
Canceling a menu stops controller timing for that menu. The controller may still be run-
ning time for another menu. Users may cancel a menu in order to run another one, to
stop menu operation for any reason, or when preparing to shut off the fryer.
• Press the active menu key for 2 seconds.
The display presents time remaining if another menu is active, otherwise [`idle]
or the time of day.
Change or Restart Menus
• With the controller in idle, press the key for the menu you want to run.
Temperature Alarms
The controller will alert you to temperature alarm conditions if they occur. If an alarm
occurs, take action as determined by your supervisor. See the Appendix in the Hardware
& Software Setup Guide for a Troubleshooting Chart and a summary of temperature
alarms.
Errors
The controller will alert you to errors if they occur. Errors are critical problems that
shut down the unit. If an error occurs, an error message will appear on the display. You
should switch off the power and call for service.
See the Appendix in the Hardware & Software Setup Guide for a Troubleshooting Chart
and a summary of errors.