Watlow MINICHEF Deep Fat Fryer Application - Manual (Page 16)

1 4 ■ Wa t l o w M I N I C H E F 2 0 0 0 A p p l i c a t i o n 1 1
Program Mode Quick Reference
These are the functions, parameters and values included in the Program Mode for this
application. You must select Application 11 to access them. For menu programming
directions, see the Hardware & Software Setup Guide. The Appendix of that guide
includes a detailed explanation of all parameters and values.
Function Parameter Value
[M`__] Menu [stpt1] Set point 1 Temperature range low
Numbers 1 - 40 Temperature for set point 1 to range high
[TiNe1] Time 1 Setting Time 1 to 0 invalidates
Run time of set point 1 selected menu. Format varies
based on configuration.
[ALArn] Mid-menu alarm Stir, Add, Flip, Turn, Alert,
setting None
[AtinE] Mid-menu alarm time 0 to Time 1
(not visible when alarm set to None)
Auto-tuning note:
Before auto-tuning Application 11, Setpoint 1 must first be set to a value that is typical
of your application. (See the Hardware & Software Setup Guide for information on pro-
gramming menus.) Then set [tHErL] / [tunE1] to [```on]. After you accept this
[```on] setting, by pressing “Enter,” the display will present [`tunE] when the auto-
tuning is taking place.
The controller will cancel the auto-tuning process if it cnnot be completed in 80 minutes.
You can cancel the auto-tuning process at any time be pressing either key C or Key D
and accepting [``Off], by pressing “Enter,” when it appears.