beautypg.com

Adjust a menu while cooking, Cancel a menu, Change or restart menus – Watlow MINICHEF Deep Fat Fryer Application User Manual

Page 34: Manual basket lift, Event outputs, Temperature alarms

background image

3 2

Wa t l o w M

I N I

C

H E F

2 0 0 0

A p p l i c a t i o n 1 2

5. To repeat cooking, repeat steps 1 through 5.

Adjust a Menu While Cooking

You can adjust the temperature and time settings during the cooking and hold
sequences by performing the actions shown under “Set the Menu” earlier in this section.

Changes can be made to temperature and time only during the portion of the cooking
sequence in which they are active. For example: a change to the first cooking tempera-
ture [tENP1] can be made only when the first cooking temperature is being run during
the cooking sequence.

Temperature changes made while cooking are saved and become part of the permanent
menu. Time changes are not saved and do not become part of the permanent menu.

Cancel a Menu

Canceling the menu stops controller operation completely. The controller does not main-
tain set point temperatures or run time. Users may cancel the control operation in order
to run another one, to stop control operation for any reason, or when preparing to shut
off the fryer.

Press the Start/Stop key for 2 seconds.

Heat outputs will switch off. Heat output indicator lights will switch off. The dis-
play presents [`idle] or the time of day will appear on the display.

Change or Restart Menus

1.

Set time and temperature as shown earlier.

2.

Press the Start/Stop key.

Manual Basket Lift

You can raise or lower the basket manually at any time by pressing the Down-arrow key
(to lower) or the Up-arrow key (to raise). If you raise the basket while cooking, the timer
will pause. Countdown time will resume when you lower the basket or when you press
the active menu key.

ç

WARNING: The Basket Up and Basket Down Keys cause or initiate motion. Appropriate reasonable care should be

taken to prevent personal injury or machine damage as a result of operator initiated or unexpected machine motion.

Event Outputs

While running a menu:

Event output 1 is activated to lift the basket for the length of time programmed in
Configuration Mode [EtyPE] / [btinE].

Event output 2 is activated to lower the basket for the length of time programmed in
Configuration Mode [EtyPE] / [btinE].

Only one output can be on at a time.

Temperature Alarms

The controller will alert you to temperature alarm conditions if they occur. If an alarm
occurs, take action as determined by your supervisor. See the Appendix in the Hardware