Run a menu (with no preheat feature), Idle, Alert – Watlow MINICHEF Deep Fat Fryer Application User Manual
Page 21: I n i, H e f

A p p l i c a t i o n 1 1
Wa t l o w M
I N I
C
H E F
2 0 0 0
■
1 9
With Sound set to 0: The controller automatically switches to idle. [`idle] or cur-
rent time will appear on the display. The Start/Stop key indicator light will flash
slowly. The controller will maintain temperature at the programmed set point.
With Sound set to 1, 2, or 3: [``End] will appear on the display and an audible tone
will be emitted. The Start/Stop key indicator light will flash rapidly. You can
acknowledge and silence the tone by pressing the Start/Stop key or it will automati-
cally time out within 2 seconds for setting 1 or 20 seconds for settings 2 or 3 and
then go into idle. The Start/Stop key indicator light will flash slowly. The controller
will maintain temperature at the programmed set point.
With sound set to 4 or 5: [``End] will appear on the display and the Start/Stop key
indicator light will flash rapidly. You must acknowledge the audible tone by pressing
the Start/Stop key. Once acknowledged the audible tone is silenced and the con-
troller goes into idle. The Start/Stop key indicator light will flash slowly. The con-
troller will maintain temperature at the programmed set point.
7.
The basket will raise automatically based on the value programmed in the
Configuration Mode [Etype] / [Btine].
8.
To repeat cooking, repeat steps 1 through 7.
Run a Menu (with no preheat feature)
This procedure describes how to run an active menu when the preheat feature is inac-
tive - in other words, when the [ready] parameter in the [setUp] function of the
Configuration Mode is set to [```no].
1.
Select the menu you want to run as shown earlier in “Select a Menu”.
2.
With [`idle] or time of day on the display, place the food in the basket.
3.
Press the Start/Stop key. The basket will lower automatically for the amount of time
set in the Configuration Mode under [Etype] / [Btine].
The Start/Stop key indicator light will light up. Time will count down on the display.
4.
If programmed, as the time counts down, a mid-point alarm will appear on the dis-
play.
The alarm message which varies based on programming will appear for ten seconds.
An audible will sound for five seconds. Time will continue to count down on the dis-
play
5.
When the cooking cycle is finished one of the following will happen, depending on
the way the controller was programmed at [EtyPE] / [Sound]:
With Sound set to 0: The controller automatically switches to idle. [`idle] or cur-
D
E
C
F
M
INI
C
HEF
2000
[`idle]
Edit
Accept
Back-Up
Exit
D
E
C
F
M
INI
C
HEF
2000
[`0009]
Edit
Accept
Back-Up
Exit
B
D
E
C
F
M
INI
C
HEF
2000
[`idle]
Edit
Accept
Back-Up
Exit
G
H
A
A
B
G
H
A
B
G
H
D
E
C
F
M
INI
C
HEF
2000
[alert]
Edit
Accept
Back-Up
Exit
A
B
G
H
STEADY
ON
SLOW
FLASH
D
E
C
F
M
INI
C
HEF
2000
[``EnD]
Edit
Accept
Back-Up
Exit
B
D
E
C
F
M
INI
C
HEF
2000
[`idle]
Edit
Accept
Back-Up
Exit
G
H
A
A
B
G
H
RAPID FLASH
IF PROGRAMMED
SLOW FLASH