Watlow MINICHEF Deep Fat Fryer Application - Manual (Page 3)

Application 10
Automatic Deepfat Fryer
with Autolift Control
Single Heat Channel, Four Menus
Introduction to Application 10 . . . . . . . . . . . . . . 1
Configuration Mode Quick Reference . . . . . . . . . 3
Program Mode Quick Reference . . . . . . . . . . . . 4
Step 7 Design a Faceplate Overlay . . . . . . . . . . . 5
Step 8 Operate the Controller . . . . . . . . . . . . . . 6
Application 10 allows you to program as many as four menu keys, each of which can control one
heat channel, one cooking time, a mid-point alarm and autolift capability. The application
includes up to four menus that control fryer temperatures and cooking time.
Overview of Key Steps
1. Install the M INI C HEF 2000.
2. Wire the controller.
3. Configure the controller.
4. Program the menus.
5. Set the controller security.
6. Set the Real-time Clock.
For instructions on Steps 1, 2, 3, 4, 5 and 6, see the Hardware & Software Setup Guide.
7. Design, manufacture and apply faceplate overlay for end-users. (For a suggested design to
suit this application, see this section. For overlay dimensions and guidelines, see the
Hardware & Software Setup Guide.)
8. Operate the controller. (See this application guide.)
10