beautypg.com

Initial preheat, Preheat, The melt cycle – Watlow MINICHEF Deep Fat Fryer Application User Manual

Page 19: Run a menu (with preheat feature), Parameter in the, Function of the configuration mode is set to, Ready, Setup, Idle, 100f

background image

A p p l i c a t i o n 1 1

Wa t l o w M

I N I

C

H E F

2 0 0 0

1 7

Initial Preheat

At power-up, the unit will preheat to the temperature value set in the Configuration
Mode [Etype] / [preHt]. The display will show [Pre-`] [`HEat] followed by oil tem-
perature as the oil heats.

When the unit reaches initial preheat temperature, [Ready] will flash once on the dis-
play and an audible tone will sound for 2 seconds. Then [`idle] will appear on the dis-
play. If Real Time Clock option is installed and [setUp] / [Cloc`] is set to [``yes],
the time of day will appear on the display.

Preheat

If in the Configuration Mode [SEtUP] / [ready] has been set to yes, the controller will
detect temperatures and preheat to operating temperature (above relative set point
minus the ready band) as required.

Activate the menu by pressing the Start/Stop key.

If the fryer is not at operating temperature, it will preheat. Meanwhile:

The word [Pre-`] [`Heat] will appear on the display for a few moments. The
Start/Stop key indicator light will flash slowly. The temperature of Channel 1 will be
displayed until the operating temperature is reached.

The heat output indicator light - G, just below the display- will light up whenever
the controller is calling for heat.

When the fryer is at operating temperature (above relative set point minus the
ready band) [ready] will appear on the display and the Start/Stop key indicator
light will flash rapidly. You are now ready to cook with the active menu.

If the fryer is at operating temperature, the display goes directly to [ready] with-
out indicating preheat or temperature.

The Melt Cycle

To avoid burning, congealed oil requires a slow heating action. If, in the Configuration
Mode, [etype] / [melt] has been set to on, when the oil temperature is below 212ºF
the heat output will be limited to 10% of full power.

Run a Menu (with preheat feature)

This procedure describes how to run an active menu when the preheat feature is inac-
tive — in other words, when the

[ready]

parameter in the

[setUp]

function of the

Configuration Mode is set to

[``yes]

.

A

B

D

E

C

F

G

H

M

INI

C

HEF

2000

[`idle]

Edit

Accept

Back-Up

Exit

SLOW

FLASH

AT OPERATING TEMPERATURE

(PREHEAT CONDITION MET)

RAPID

FLASH

B

D

E

C

F

M

INI

C

HEF

2000

[100f`]

Edit

Accept

Back-Up

Exit

B

D

E

C

F

M

INI

C

HEF

2000

[ready]

Edit

Accept

Back-Up

Exit

G

H

G

H

A

A

[pre-`] [`Heat]

D

E

C

F

M

INI

C

HEF

2000

[`50`f]

Edit

Accept

Back-Up

Exit

D

E

C

F

M

INI

C

HEF

2000

[ready]

Edit

Accept

Back-Up

Exit

A

B

G

H

A

B

G

H

D

E

C

F

M

INI

C

HEF

2000

[`idle]

Edit

Accept

Back-Up

Exit

A

B

G

H