Program mode quick reference – Watlow MINICHEF Deep Fat Fryer Application User Manual
Page 80

7 8
■
Wa t l o w M
I N I
C
H E F
2 0 0 0
A p p l i c a t i o n 1 7
Program Mode Quick Reference
These are the functions, parameters and values included in the Program Mode for this
application. You must select Application 17 to access them. For menu programming
directions, see the Hardware & Software Setup Guide. The Appendix of that guide
includes a detailed explanation of all parameters and values
F
unction
Parameter
Value
Your Settings
[M`__] Menu Numbers 1 - 4
[TiNe1] Time 1
Format varies based
Run time of set point.
on configuration.
[alarn] Mid-menu
Stir, Add, Flip, Turn, Alert,
Alarm
None
[atiNe] Mid-menu 0
to
[TiNe1].
alarm time.
Auto-tuning Note:
Before auto-tuning Application 17, set point parameter at [Etype] / [Setpt] must first
be set to a value that is typical of your application. (See the Hardware & Software
Setup Guide for information on programming menus.) Then set [tHerl] / [tunE1] to
[```on]. After you accept [```on], by pressing “Enter,” the controller will display
[`tunE] while auto-tuning is taking place.
The controller will cancel the auto-tuning process if it cannot be completed in 80 min-
utes. You can cancel the auto-tuning process at any time by pressing either key C or key
D and accepting [``Off], by pressing “Enter,” when it appears.