Auxiliary idle set points, Idle – Watlow MINICHEF Deep Fat Fryer Application User Manual
Page 22

2 0
■
Wa t l o w M
I N I
C
H E F
2 0 0 0
A p p l i c a t i o n 1 1
rent time will appear on the display. The Start/Stop key indicator light will flash
slowly. The controller will maintain temperature at the programmed set point.
With Sound set to 1, 2, or 3: [``End] will appear on the display and an audible tone
will be emitted. The Start/Stop key indicator light will flash rapidly. You can
acknowledge and silence the tone by pressing the Start/Stop key or it will automati-
cally time out within 2 seconds for setting 1 or 20 seconds for settings 2 or 3 and
then go into idle. The Start/Stop key indicator light will flash slowly. The controller
will maintain temperature at the programmed set point.
With sound set to 4 or 5: [``End] will appear on the display and the Start/Stop key
indicator light will flash rapidly. You must acknowledge the audible tone by pressing
the Start/Stop key. Once acknowledged the audible tone is silenced and the con-
troller goes into idle. The Start/Stop key indicator light will flash slowly. The con-
troller will maintain temperature at the programmed set point.
6.
The basket will raise automatically based on the value programmed in the
Configuration Mode [Etype] / [Btine].
7.
To repeat cooking, repeat steps 1 through 6.
Auxiliary Idle Set Points
In some cases you may want to control at some non-cooking temperature such as during
cleaning, preheating or to preserve the life of the oil. The controller is equipped with the
capability of two auxiliary idle set points: Idle 1 and Idle 2.
To program either of the set points:
1.
Press and hold down the Idle 1 Temp or Idle 2 Temp key.
2.
While holding down the key, use the Up-arrow or Down-arrow key to adjust the set
point temperature.
3.
Release all of the keys.
The idle temperature has been set.
4.
Program the other Idle temperature if desired by repeating 1 through 3 using the
other Idle Temp key.
To run the fryer at an auxiliary idle set point:
•
With the fryer in idle (not running a menu) press either the Idle1Temp or Idle2
Temp key.
The indicator light over the Idle Temp key will flash slowly.
The fryer will run at the idle set point until you run a menu by pressing the
Start/Stop key or you press the other Idle Temp key.
D
E
C
F
M
INI
C
HEF
2000
[`idle]
Edit
Accept
Back-Up
Exit
D
E
C
F
M
INI
C
HEF
2000
[`0009]
Edit
Accept
Back-Up
Exit
A
B
G
H
A
B
G
H
STEADY
ON
SLOW
FLASH