3 sata drive connection, Connector, Type – IEI Integration NANO-945GSE2 User Manual

Page 73: Label, Ethernet con

NANO-945GSE2

Page 59

Step 1:

Align the connectors. Make sure that the connectors are lined up correctly.

The connectors should match up with the slot of the same shape.

Step 2:

Push straight down until the card is properly seated. Push the card straight

downwards to connect. Use a firm pushing action to connect. When the cards

are connected properly there will be no gaps between the baseboard connectors

and the card connectors.

Step 0:

4.7.3 SATA Drive Connection

The NANO-945GSE2 is shipped with two SATA drive cables and one SATA drive power

cable. To connect the SATA drives to the connectors, please follow the steps below.

Step 1:

Locate the connectors. The locations of the SATA drive connectors are shown

in Chapter 3.

Step 2:

Insert the cable connector. Press the clip on the connector at the end of the

SATA cable and insert the cable connector into the onboard SATA drive

connector. See

Figure 4-12.