IEI Integration NANO-945GSE2 - Manual (Page 58)

NANO-945GSE2
Page 44
4.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the installation of the
NANO-945GSE2 may result in permanent damage to the
NANO-945GSE2 and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the NANO-945GSE2. Dry climates are especially susceptible to ESD. It is
therefore critical to strictly adhere to the following anti-static precautions whenever the
NANO-945GSE2, or any other electrical component, is handled.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding:- Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: When configuring the NANO-945GSE2, place it on
an antic-static pad. This reduces the possibility of ESD damaging the
NANO-945GSE2.
Only handle the edges of the PCB:-: When handling the PCB, hold the PCB
by the edges.
4.2 Installation Considerations
NOTE:
The following installation notices and installation considerations should
be read and understood before the NANO-945GSE2 is installed. All
installation notices pertaining to its installation should be strictly
adhered to. Failing to adhere to these precautions may lead to severe
damage of the NANO-945GSE2 and injury to the person installing it.