beautypg.com

ZOLL Propaq MD Rev A User Manual

Page 76

background image

C

HAPTER

3

D

ISASSEMBLY

P

ROCEDURES

72

9650-0807-01 Rev. A

3

Disconnect the sensor in the area
illustrated.

4

Disconnect the exhaust tube connector
from the air vent at area shown.

Note: Lift both sides at the same time to
pull out.

5

Remove EtCO2 module.

6

Cut the tie wrap holding the NIBP unit.

7

Remove three (3) screws from NIBP unit.

Note: During reassembly, torque screws to
6 in-lbs.

8

Disconnect the four (4) NIBP tubes in the
illustrated locations and remove the NIBP
unit.

NIBP
hoses