beautypg.com

Disassembling the main unit – ZOLL Propaq MD Rev A User Manual

Page 67

background image

Disassembling the Main Unit

9650-0807-01 Rev. A

Propaq MD Service Manual

63

Disassembling the Main Unit

Tool Required

# 1 Phillips screwdriver with torque capability

Wooden stick

Kapton tape

Setup

This procedure should be conducted on a static mat.

Wear a wrist strap to ground during the procedure.

Complete these procedures in the following order before performing this procedure:

1.

“Removing the Handle” on page 61

2.

“Removing the Printer Module” on page 62

To reassemble the main unit, reverse the steps.

Main Unit Disassembly

1

Place tape on the top of the unit (near the
front of the display) in the illustrated area.

2

Gently place unit screen so the display is
facing down.

3

Remove ten (10) screws: four (4) on the
top, four (4) on the bottom, and two (2) in
the middle in the illustrated areas. Take
care to keep the two parts of the unit
together.

Note: During reassembly, torque screws to
6 in-lbs.

4

While holding the two parts of the unit
together, place the unit vertically on the mat
(feet down).

5

Separate the top part of the unit by creating
a small gap, and remove any screws that
are in the way.