beautypg.com

Removing the etco, And nibp modules – ZOLL Propaq MD Rev A User Manual

Page 75

background image

Removing the EtCO2 and NIBP Modules

9650-0807-01 Rev. A

Propaq MD Service Manual

71

Removing the EtCO

2

and NIBP Modules

Tool Required

# 1 Phillips screwdriver with torque capability

Wooden stick

Large diagonal cutters

Setup

This procedure should be conducted on a static mat.

Wear a wrist strap to ground during the procedure.

Complete these procedures in the following order before performing this procedure:

1.

“Removing the Handle” on page 61

2.

“Removing the Printer Module” on page 62

3.

“Disassembling the Main Unit” on page 63

4.

“Removing the Front Enclosure Module” on page 66

To assemble the EtCO

2

and/or NIBP modules, reverse the steps.

EtCO

2

and/or NIBP Disassembly

1

Unplug the power connector (shown in
illustration).

Note: During reassembly, torque screws to
6 in-lbs.

2

Remove four (4) screws around the EtCO

2

unit.

Note: During reassembly, torque screws to
6 in-lbs.