beautypg.com

ZOLL Propaq MD Rev A User Manual

Page 73

background image

Removing the Display Module

9650-0807-01 Rev. A

Propaq MD Service Manual

69

4

Using the 6mm socket wrench, remove the
hex standoff located underneath the screw
you just removed.

Note: During reassembly, torque to
6 in-lbs.

5

Flip the unit back over so the display
screen is facing up.

6

Lift the casting up while pushing down on
the rubber boot that runs around the edge
of the LCD screen.

7

Remove the copper tape from the casting.

Note: During reassembly, apply new
copper tape for grounding.

8

Disconnect the LCD display cable
connectors from the back of the LCD
screen to release it.

hex standoff

boot

copper tape

cable connectors