Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 62)

46
CATC M ERLIN ’ S W AND 2.00 C HAPTER 4
User’s Manual Command Generator
Clicking the HCI Customized List button , which is located to the left of
the Execute button in Command Generator, will open the Command Group
interface.
To remove commands from the customized HCI command list, select the
radio button beside one of the groups listed in the “Command groups”
section of the interface, then press the Remove button
. The
selected command(s) will move into the “Other HCI commands” list.
To add commands to the customized list, select the radio button next to the
group of commands that should be moved, then press the Add button
. The selected command(s) will be moved from “Other HCI
commands” to the customized HCI command list.
4.3 Tables of Available Commands
The following tables summarize the commands in Command Generator.
For detailed descriptions of the commands, see Appendix A: Command
Generator Command Descriptions, on page 87.
Note
“N/A” means Not Applicable. This indicates that the specified
command does not have a parameter.
HCI Commands
Link Control Commands
Two sections of Link Control Commands are presented. The first section
lists commands that are supported by Merlin’s Wand. The second section
presents commands that are not supported.