Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 47)

31
CATC M ERLIN ’ S W AND 2.00 C HAPTER 3
User’s Manual Profile Wizard
manually enter the security settings. If you choose this option, press
Next to open the Local Device Manager. When you close the dialog,
Step 4 will be performed automatically.
Step 4
Press Next.
At this point, please refer to the section that describes the setup for the
particular profile that the target device uses:
•
Section , “Emulate Device: Dial-Up Gateway” on page 31
•
Section , “Emulate Device: Fax Gateway” on page 32
•
Section , “Emulate Device: File Transfer” on page 33
•
Section , “Emulate Device: HCRP Server” on page 33
•
Section , “Emulate Device: Headset” on page 34
•
Section , “Emulate Device: Headset Audio Gateway” on page 35
•
Section , “Emulate Device: LAN” on page 35
•
Section , “Emulate Device: Object Push” on page 36
•
Section , “Emulate Device: PAN - GN” on page 36
•
Section , “Emulate Device: PAN - NAP” on page 37
•
Section , “Emulate Device: Serial Port” on page 38
Emulate Device: Dial-Up Gateway
These steps show how to use Profile Wizard to configure Merlin’s Wand to
emulate a dial-up gateway device.
Step 1
Complete Steps 1-4 in Section 3.3, “Emulating Devices” on
page 30.
The Select Dial-Up Emulation screen will open.
Step 2 You may choose to configure Merlin’s Wand to emulate a
dial-up gateway device while connected to or emulating a
modem or while connected to a virtual COM port.
To connect to a modem:
(a) Select “Connect to modem” and choose a modem from the list.
(b) Press Next.
At this point, initialize a connection to Merlin’s Wand from a
Bluetooth device that uses the Dial-Up Gateway profile. When the
connection has been established, the modem status can be observed
via the status lights.
(c) (Optional) Enable or disable event logging:
You can configure Merlin’s Wand to write incoming or outgoing data
to the Event Log by checking or unchecking the “Log Incoming
Data” and “Log Outgoing Data” options.