Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 143)

127
CATC M ERLIN ’ S W AND 2.00 C HAPTER A
User’s Manual Command Generator Command Descriptions
SetLineStatus
This command will send the LineStatus command to the remote device. It
allows the RFCOMM user to communicate overrun framing and parity
errors to the remote device.
SetModemStatus
This command will send the ModemStatus to the remote device. It allows
the user to send Flow Control and V.24 signals to the remote device.
Return Events
SendTest_Complete
SendTest_Failed
Command Parameters Examples Comments
(HCI/DLCI) (0x0001, 0x02) LineStatus Values:
LineStatus 0x0F 0x01 -- Set to indicate an
error.
0x02 -- Set to indicate an
overrun error.
0x04 -- Set to indicate a
parity error.
0x08 -- Set to indicate a
framing error.
Return Events
SetLineStatus_Complete
SetLineStatus_Failed
Command Parameters Examples Comments
(HCI/DLCI) (0x0001,
0x02)
ModemSignals 0x8C Modem Signal Values:
0x8c - Ready to communicate, ready to receive,
and data valid
0x02 (FLOW) - Set when sender is unable to
receive frames
0x04 (RTC) - Set when sender is ready to
communicate.
0x08 (RTR) - Set when sender is ready to
receive data.
0x40 (IC) - Set when a call is incoming.
0x80 (DV) - Set when valid data is being sent.