Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 44)

28
CATC M ERLIN ’ S W AND 2.00 C HAPTER 3
User’s Manual Profile Wizard
Start Range and End Range: Start Range defines the beginning of
the range, and End Range defines the end of the range. Only the
protocol types or multicast addresses that fall within the range will be
sent by the remote device; all other types or addresses will be filtered
out.
For Filter Network Type Set Message, the Start and End Ranges may
be in the format nnnn or 0xnnnn. For the Filter Multicast Address Set
Message, the Start and End Ranges can be in the format
nnnnnnnnnnnn or 0xnnnnnnnnnnnn.
•
Send Packet: Use this to send an ethernet packet to the remote
device. The types of ethernet packets that can be sent are General,
Compressed, Compressed Source Only and Compressed Destination
Only.
Note Depending on your network settings for ‘CATC Bluetooth Trainer PAN Virtual
NIC’ Local Connection, Windows may create additional network traffic over this
connection. Check your network properties for ‘CATC Bluetooth Trainer PAN virtual
NIC.’
Connect to Device: PAN–NAP
Follow these steps to configure Merlin’s Wand to connect to a Bluetooth
device that supports the Personal Area Network–Network Access Point
profile.
Note To connect to a device that uses the PAN profile, you must install the virtual
network driver that is included with the Merlin’s Wand installation. For instructions, see
Section 3.7, “Installation of Network Driver,” on page 41.
Step 1
Complete steps 1-6 in Section 3.2, “Connecting to Devices”
on page 17.
Step 2 Select PAN - NAP from the list on the Select Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
Merlin’s Wand to switch roles during the connection.
Step 3
Click Next.
The Wizard will advance to the Connection Status screen. Merlin’s
Wand will attempt to establish an ACL connection to the remote device,
and then open a BNEP connection to it. Merlin’s Wand will then send a
Setup Connection Request Message. When Merlin’s Wand receives the
Setup Connection Response Message from the remote device, network
services may be accessed.