IAI America IX-NNN1805 - Manual (Page 18)

12
When transporting the robot while it is still attached to the equipment, etc., fabricate a metal bracket like the one
shown below and use the bracket to secure arm 2 to a platform, etc.
Move the robot slowly by paying attention to the balance of the robot and being careful not to apply vibration or
shock.
The tapped holes on both sides of arm 2 are through holes, so do not use screws of 6 mm or longer. Such
longer screws may contact the internal mechanism.
x If you hold the robot only by arm 2 or an excessive load is applied on arm 2, the robot may be damaged.
x If the robot is dropped during transport, injury may occur or the robot may be damaged.
x When transporting the robot while it is still attached to the equipment, etc., be sure to secure arm 2. Also be
careful not to apply vibration or shock during transport.
Platform
Warning Danger
1.6 25
12.5
6
15
12.
5
5
150
‡4 hole
Arm securing
bracket
Material: SPCC or
equivalent
‡5 hole
(150)
145
r 0.7