IAI America LSA-S10SS User Manual
Page 58

6. Maintenance and Inspection
52
4) Adjusting the Stainless Sheet Tension
Adjust the stainless sheet in the direction of the arrow until the check lines on the side covers
are offset from the check line on the stainless sheet by 0.5mm. (Refer to the enlarged view of
A.)
(The stainless steel sheet is gripped on with the magnets. Detach the sheet in a manner of
peeling it once from one edge.)
Enlarged view of A
A
Side covers
Stainless sheet
Offset
Move the stainless sheet in the direction of the arrow to fine-tune the sheet position until the
check lines on the side covers are offset from the check line on the stainless sheet by 0.5mm.
Once this adjustment is complete, an approximately 1mm clearance has been achieved
between the top surface of the stainless sheet and the back of the slider cover at the center of
the slider cover.
5) After the sheet has been positioned, loosely tighten the thin-head screws removed earlier until
the stainless sheet no longer moves.
Loosely tighten the thin-head screws removed earlier
until the stainless sheet no longer moves.