IAI America LSA-S10SS - Manual (Page 40)

2. Installation
34
2.3.2 Installation of Main Unit
Caution: The stainless sheet is designed very thin (thickness: 0.1 mm) in order to ensure
flexibility. Therefore, the stainless sheet is easily dented or scratched.
When installing the stainless sheet, pay attention to the following points:
1. Do not press the sheet directly with hands.
2. Be careful not to drop a tool or a work piece on the sheet and make a dent mark.
3. Do not generate powder dust or iron powder around the stainless sheet.
There are magnets attached on the side cover to grip the stainless steel sheet. Handle
the product with special care so the magnets would not grip metal pieces and dusts.
If dust/powder has generated, thoroughly remove attached dust/powder from the
stainless sheet after the operation.
If the actuator is operated with the stainless sheet carrying foreign particles, the
particles may enter the slider and damage the sheet or cause the sheet to deform, lift or
present other problems.