IAI America LSA-S10SS - Manual (Page 24)

1. Specifications Check
18
1.2.5 Allowable Load Moments of the Actuator
Allowable Dynamic Load Moment
[N·m]
Type
Ma Mb Mc
Allowable Overhang
Load Length (L) (Note 1)
S6SS, S6SM 28.9 41.2 22.5
Ma direction: 300mm or less
Mb, Mc direction: 300mm or less
S8SS, S8SM
S8HS, S8HM
42.2 60.3 37.6
Ma direction: 300mm or less
Mb, Mc direction: 300mm or less
S10SS, S10SM
S10HS, S10HM
57.4 81.9 60.8
Ma direction: 300mm or less
Mb, Mc direction: 300mm or less
Note 1: The values for allowable overhang load length are those when the center of the gravity of
the load is at 1/2 of the overhang length.
Conduct moment calculations for Ma and Mc with the point indicated with an allow below as the
datum.
Caution: Using the product above the allowable moment or overhang load length may cause
not only to generate abnormal noise or vibration, but also to shorten the product life
remarkably.
1.2.6 Duty Ratio in Continuous Operation
The duty ratio may differ depending on the acceleration/deceleration and transported weight.
[Refer to 1.3 “Operating conditions”]
Dimension A
S6SS, SM : 69mm
S8SS, SM, HS, HM : 79mm
S10SS, SM, HS, HM : 99mm
Slider top surface
Guide
A
Mb
Ma Mc
Drawings for Standard Type
Mb or Mc direction
L
Ma direction
L
Drawings for Standard Type