IAI America LSA-S10SS - Manual (Page 54)

6. Maintenance and Inspection
48
6.4 Interior Inspection
With the power supply turned OFF, turn up the stainless sheet and visually inspect the interior.
Check the following items inside the actuator.
Actuator
Loosening of actuator
mounting bolts, etc.
Guide Lubrication condition, soiling
Visually check the interior condition. Focus on entry of dust and other foreign matters and the
lubrication condition.
Even if grease has turned brown, the actuator is lubricated properly if its traveling surface is glossy.
Contact IAI if an abnormality is found on the guide part.
The procedure to check the interior is specified below:
1) Move the slider toward the home side.
2) Remove the covers.
Covers Covers
3) Remove the screws securing the sheet using a hex wrench with a width across flats of 2.5mm.
4) Turn up the sheet and check the interior.
5) After the check, assemble the parts by following the same steps in the reverse order.
Caution:
• When peeling off the stainless steel sheet, be careful not to get pulled in the body by the
strong magnetic force of the magnets inside.
In case of getting pulled by the magnets inside, the stainless steel sheet may get damaged
and may not be used any more. Contact IAI if the sheet is damaged.
• Do not attempt to change the mounting condition by pulling the sheet. Change in the
mounting condition may give an impact to the alignment of the sheet or the life of it.
• When working with the stainless sheet, wear gloves or take other appropriate precautions to
prevent cuts by the edges of the sheet.
6.5 Cleaning the Interior
• Wipe dirty areas using a soft cloth, etc.
• Do not blow highly compressed air onto the actuator, as it may cause dust to enter the actuator
through gaps between parts.
• Do not use petroleum-based solvent, neutral detergent or alcohol.