IAI America SSPA User Manual
Page 83

14. Motor Replacement Procedures
75
(5) Removing the motor unit
[1] Loosen the coupling tightening bolt.
Caution: If the actuator is installed vertically, exercise due
caution not to let the slider drop.
Hold the slider (work part) from the outside to
prevent it from dropping, and then loosen
the coupling bolt.
Remove the bolts used to secure the motor using an Allen wrench of 4 mm across flats, and pull out the
motor unit and coupling from the motor housing.
Motor affixing bolt
Motor affixing bolt
Motor affixing bolt
Motor affixing bolt
Motor
Body
Motor