IAI America SSPA - Manual (Page 44)

6. Installation
36
z SSPA
Unless it is the optional rust-proof model (model code: MD), there is no rust-proof treatment (plating or paint
coating) conducted on the base datum surface (bottom surface and datum side surface) nor slider datum
surface (top surface and datum side surface).
Before installing the actuator and the work part, remove any dirt or oil from the reference surface with a
waste cloth soaked with alcohol and grease, wipe it off again with a dry waste cloth, and brush paint it with
anti-corrosion oil.
(JIS K 2246 NP-3-1 or equivalent anti-corrosion oil is applied when shipped from IAI.)
Slider reference surface (side)
On the right facing from the motor
Slider reference surface (top)
Reference surface (side)
On the right facing from the motor
Reference surface (bottom)
Motor side
View from the upper side
Quasi-reference surface Reference surface
Quasi-reference surface
Shoulder dimensions to the base and
slider reference surfaces (side)
Type A
Slider reference surface (side) 2 to 9
Base reference surface (side) 3 to 8