IAI America SSPA User Manual
Page 77

12. Maintenance/Inspection
69
(2) Adding grease to the intermediate support
Applicable models: ISB, ISPB MXMX/LXMX/LXUWX
[Connecting rods]
After cleaning the two connecting rods at the intermediate support, apply grease to the rods using a finger.
Thereafter, move the slider back and forth to let the grease spread evenly.
[Support bushes]
After cleaning the support bushes at both ends of the intermediate support, apply grease to the areas around
the bushes using a finger while turning each support bush. Thereafter, move the slider back and forth to let
the grease spread evenly.
[Top of slider and intermediate support]
After cleaning the top of the slider and top of the intermediate support at both ends, apply grease to these
areas using a finger. This is to protect the top of the slider and intermediate support against contact with the
screw cover.
Caution: In case the grease got into your eye, immediately go to see the doctor to get an appropriate care.
After finishing the grease supply work, wash your hands carefully with water and soap to rinse the
grease off.
Connecting rod
Support bush
Top of slider
Top of intermediate support