IAI America RCS2-A6R User Manual
Page 58
4. Maintenance Inspection
52
(6) Check the following points before restoring the home position:
�
The motor side should be aligned with the initial countermark. If the position is offset, adjust
it to achieve proper alignment.
�
The ball screw side should be at a position where the slider projects A4R is 0.6mm, A5R
and A6R is 0.7mm from the mechanical end.
After the check, attach a new belt while holding the pulleys on both sides in position.
�
�
�
�
�
�
Initial countermark
position
Corresponding to the slider position
of 0.6mm away from the
mechanical end for A4R or 0.7mm
away for A5R and A6R
Motor side
Ball screw side