IAI America RCS2-A6R - Manual (Page 36)

2. Installation
30
Type
In the case that steel is used for
the bolt seating surface:
In the case that aluminum is used
for the bolt seating surface:
A4R M3×8 M3×12
A5R M4×8 M4×12
A6R M5×10 M5×15
Caution: Pay special attention when selecting the bolt length. In case that an inappropriate
length of a bolt is applied, it may cause a drop in the operation accuracy or an
unexpected accident due to a damage, insufficient strength of actuator attachment
or an interference with the operating area.
2.3.3 Mounting Surface
� The platform to install the actuator should possess a structure that ensures enough stiffness,
and should be free from vibration.
� The surface where the actuator will be mounted should be a machined surface or that with an
accuracy equivalent to it, and the flatness should be 0.05mm/m or below.
� Have enough space for the maintenance work.
The side and bottom surfaces of the base on the actuator work as the datum surfaces for the side
of the slider.
Secure the main body with the mounting holes
on the base of this machine.
Use the hexagon socket head bolts shown
below.
After securing the main body, reinstall the
screw cover.