beautypg.com

Evolver 303 dual purge robotic atomizers - safety – Ransburg Evolver 303 Dual Purge Solvent Robotic Applicator A12374-XXX User Manual

Page 7

background image

AREA

Tells where hazards
may occur.

HAZARD

Tells what the hazard is.

SAFEGUARDS

Tells how to avoid the hazard.

Spray Area

Improper operation or mainte-

nance may create a hazard.

Personnel must be properly

trained in the use of this equip-

ment.

Personnel must be given training in accordance with the

requirements of NFPA-33.

Instructions and safety precautions must be read and

understood prior to using this equipment.

Comply with appropriate local, state, and national codes

governing ventilation, fire protection, operation mainte-

nance, and housekeeping. Reference OSHA, NFPA-33, and

your insurance company requirements.

General Use and

Maintenance

Fire Hazard

Improper or inadequate oper-

ation and maintenance proced-

ures will cause a fire hazard.

Protection against inadvertent

arcing that is capable of causing

fire or explosion is lost if any

safety interlocks are disabled

during operation. Frequent

power supply shut-down indi-

cates a problem in the system

requiring correc-tion.

Fire extinguishing equipment must be present in the spray

area and tested periodically.

Spray areas must be kept clean to prevent the accumula-

tion of combustible residues.

Smoking must never be allowed in the spray area.

The high voltage supplied to the atomizer must be turned

off prior to cleaning, flushing or maintenance.

When using solvents for cleaning:

Those used for equipment flushing should have flash points

equal to or higher than those of the coating material.

Those used for general cleaning must have flash points

above 100

°F (37.8°C).

Spray booth ventilation must be kept at the rates required

by local and/or country codes. In addition, ventilation

must be maintained during cleaning operations using

flammable or combustible solvents.

Electrostatic arcing must be prevented.

Test only in areas free of combustible material.

Testing may require high voltage to be on, but only as

instructed.

Non-factory replacement parts or unauthorized equipment

modifications may cause fire or injury.

If used, the key switch bypass is intended for use only

during set-up operations. Production should never be

done with safety interlocks disabled.

The paint process and equipment should be set up and

operated in accordance with local and/or country safety

codes.

2

Evolver 303 Dual Purge Robotic Atomizers - Safety

1

AA-08-01.1