Ransburg Evolver 303 Dual Purge Solvent Robotic Applicator A12374-XXX - Manual (Page 18)

INSTALLATION
13
Evolver 303 Dual Purge Robotic Atomizers - Installation
EVOLVER 303 DUAL PURGE
ROBOTIC ATOMIZER
INSTALLATION
This information is intended ONLY to indicate the
general installation parameters of this product and,
where applicable, its working relationship to other
Ransburg system components in typical use. Each
installation is unique and should be directed by an
authorized Ransburg representative or conducted
from the Ransburg installation drawings provided
for your particular installation.
POWER SUPPLY ASSEMBLY
Refer to the most current Power Supply Unit
manuals for complete information regarding power
supply installation.
• MicroPak Control Unit (LECU5004)
• Stand-alone control/power supply unit
(A10406)
• MicroPak Control Unit (LECU5004-31)
MOUNTING
The Evolver 303 dual purge is equipped with a quick
disconnect assembly. The quick disconnect feature
consists of a robot plate which is permanently at-
tached to the robot through a wrist adapter plate
and a mating rear plate which is part of the Evolver
303 Dual Purge Spray Applicator assembly. The ap-
plicator is secured to the robot plate with a threaded
retaining ring.
ELECTRICAL AND FIBER OPTIC
CONNECTIONS
The fiber optic cable is included in the Evolver 303
dual purge tubing bundle, but not used. It is there,
ready to use, in case a user is using or chooses to use
in the future, a bell applicator, which requires the
fiber optic cable. The fiber optic connection is made
on the back of the applicator's robot plate. The fiber
optic cable comes preassembled with connectors that
are secured in place by set screws tightened from the
side of the robot plate. An adequate ground must be
provided to the mounting plate to ensure that fluid
fittings, etc. are at ground potential.
FLUID CONNECTIONS
The paint, solvent, and dump fluid tubing are con-
nected on the back of the robot plate with stainless
steel compression fittings and PFA tubing. Fluid
tubing requirements are shown in the "Signal Iden-
tification Tables" in the "Installation" section.
TYPICAL INSTALLATION
Figure 4 shows a typical installation of the Evolver
303 dual purge and the wiring installation of the
applicator with the MicroPak.
AA-08-01.1