CognitiveTPG A760 - Manual (Page 99)

A760 User Guide: Programming Supplement
Chapter 4: Programming commands
99 Revision F January 2010
Bar codes
These commands format and print bar codes and are
described in order of their hexadecimal codes. Note: A756 firmware can be set for module widths in bar
codes ranging from 2 dots to 4 dots per module (DPM) for
the narrow modules. The default is 3 DPM.
A760 firmware range from 1 dot per module (DPM)
printed on the receipt, The default is 2 DPM.
Select printing position of HRI characters
ASCII GS H n
Hexadecimal 1D 48 n
Decimal
29 72 n
Value of n: Printing position
0 = Not printed
1 = Above the bar code
2 = Below the bar code
3 = Both above and below the bar code
Default: 0 (Not printed)
Prints HRI (human readable interface) characters above or
below the bar code.
Select pitch of HRI characters
ASCII GS f n
Hexadecimal 1D 66 n
Decimal
29 102 n
Value of n: 0 = Standard pitch at 15.2 CPI
1 = Compressed pitch at 19 CPI
Default: 0 (Not printed)
Selects standard and compressed font for printing bar code
characters.
When slip is selected as the interface, HRI is always
compressed.
Select bar code height
ASCII GS h n
Hexadecimal 1D 68 n
Decimal
29 104 n
Value of n: Number of dots
Range of n: 1–255
Default: 162
Sets the bar code height to (n/154”) for receipt and
(n/172”) for slip.