CognitiveTPG A760 - Manual (Page 16)

A760 User Guide: Programming Supplement
Chapter 2: Printer Status, Ethernet and Indicators 16 Revision F January 2010
Indicators
The printer communicates various conditions both visually, with two green LEDs or audibly, with
a series of tones or beeps. The following table lists these indicators.
Round green on-line, paper status,error LED (next to paper feed button)
Indicator Sequence Condition
LED Continuous, flashing quickly Paper out
Cover off
Knife unable to home
LED Continuous, flashing slowly Paper is low
(if paper low sensor is installed)
Printhead too hot
Voltages out of range
Tone Two-tone beep Startup diagnostics completed successfully
(low frequency, high frequency)
LED Single beep Boot CRC test failure
and Tone Single LED flash
LED Double beep SRAM test failure
and Tone Double LED flash
LED Triple beep EEPROM test failure
and Tone Triple LED flash
LED Four beeps Dynamic memory initialization failure
and Tone Four LED flash
LED Two-Tone beep Main program CRC test failure
and Tone (high frequency, low frequency) Or
Continuous flashing of LED DIP switch is in on position indicating
flash download mode
Rectangular green slip-in LED (on slip table)
Indicator Sequence Condition
LED Off No check or form inserted or are incorrectly inserted
LED On (continuous) Check or form properly inserted
For more information about See this section
Error conditions and “ Troubleshooting the
correcting them printer” on page 41, in
Chapter 4: Using the Printer,
in the A760 User Guide
The printer is also able to communicate its status to the host application if the application has been programmed to receive
this information.
For more information about See this section
Communication of printer “Command descriptions”
status to host application in Chapter 4: Programming commands