CognitiveTPG A760 User Manual
Page 53
A760 User Guide: Programming Supplement
Chapter 4: Programming commands
53
Revision F January 2010
Set right-side character spacing
ASCII
ESC SP n
Hexadecimal 1B 20 n
Decimal
27 32 n
Range of n:
0 – 32 (decimal)
Default:
0
Sets the right side character spacing to [ n x horizontal or
vertical motion units]. Values for this command are set
independently in standard and paper mode.
The units of horizontal and vertical motion are specified
by the set horizontal and vertical minimum motion units
(1D 50 …) command. Changes in the horizontal or vertical
units do not affect the current right side character spacing.
When the horizontal or vertical motion unit is changed by
the set horizontal and vertical minimum motion units (1D
50 …) command the value must be in even units and not
less than the minimum amount of horizontal movement.
In standard mode the horizontal motion unit is used.
In page mode the horizontal or vertical motion unit differs
and depends on the starting position of the printable
area. When the starting printing position is the upper left
or lower right of the printable area (set by select print
direction in page mode, 1B 54 n) the horizontal motion
unit (x) is used. When the starting printing position is the
upper right or lower left of the printable area (set by select
print direction in page mode, 1B 54 n) the vertical motion
unit (y) is used.
Exception
This is ignored in A756 emulation mode and is only valid
on the receipt station.
Select print mode
ASCII
ESC ! n
Hexadecimal 1B 21 n
Decimal
27 33 n
Value of n:
Pitch selection (standard, compressed,
double-high, or double-wide.)
Value of n
Bit
Function
0
1
Bit 0
Pitch
2
Standard
1
Compressed
(See chart below)
pitch
pitch
Bit 3
Emphasized mode Canceled
Set
Bit 4
Double-high
2
Canceled
Set
Bit 5
Double-wide
Canceled
Set
Bit 7
Underlined mode
Canceled
Set
Bits 1, 2 and 6 are not used.
1
Standard and compressed pitch cannot be used together
in the same line.
2
Double-high character cannot be used with normal
character in the same line, nor can they be used on the
slip station.
Default:
0 (for bits 0, 3, 4, 5, 7)
Selects the print mode: standard, compressed,
double-high, or double-wide.
Pitch
Receipt Receipt
Slip
Slip
Station
CPI
Station
CPI
Standard
44
15.6
66
13.9
Compressed 56
20.3
80
17.1
Related information
The bits in this command perform the same function as the
stand-alone functions:
1B 16 n
Select pitch
1B 45 n
Emphasized
1B 47 n
Double-strike
12
Double-wide
13
Single-wide
1B 2D n
Underline