CognitiveTPG A760 - Manual (Page 36)

A760 User Guide: Programming Supplement
Chapter 4: Programming commands 36 Revision F January 2010
Select receipt or slip for setting line spacing
ASCII ESC c 1 n
Hexadecimal 1B 63 31 n
Decimal
27 99 49 n
Value of n: 1, 2, 3 Select receipt
4 Select Slip
Default of n: 1
Selects which station receives the effects of the following
commands:
1.
Select Default Line Spacing (1B 32)
2. Set Line Spacing (1B 33)
3. Add n extra dot rows (16 n)
Exceptions
This command is ignored if n is out of range.
Select paper sensors to output paper end signals
ASCII ESC c 3 n
Hexadecimal 1B 63 33 n
Decimal
27 99 51 n
Value of n:
If either bit 0 or bit 1 is on, the paper roll near-end sensor
is selected as the paper sensor outputting paper-end
signals.
If either bit 2 or bit 3 is on, the paper roll-end sensor is
selected as the paper sensor outputting paper-end signals.
Bit Position Hex Decimal Function
0 Off 00 0 Paper roll near-end
sensor disabled
On 01 1 Paper roll near-end
sensor enabled
1 Off 00 0 Paper roll near-end
sensor disabled
On 02 2 Paper roll near-end
sensor enabled
2 Off 00 0 Paper roll-end
sensor disabled
On 04 4 Paper roll-end
sensor enabled
3 Off 00 0 Paper roll-end
sensor disabled
On 08 8 Paper roll-end
sensor enabled
4, 5, 6, 7 – – – Undefined
Range of n: 1–255
Default of n: 15
Specifies the paper sensor to output a paper end signal.
Multiple sensors may be selected to signal when paper
has run out. When multiple sensors have been selected,
anytime one of the sensors detects a paper end, the
paper-end signal is output.
When this command is executed a sensor is switched.
The paper-end signal switching is delayed depending on
the receive buffer state.