CognitiveTPG A760 - Manual (Page 132)

A760 User Guide: Programming Supplement
Chapter 4: Programming commands 132 Revision F January 2010
Setting raw TCPIP port 9001
ASCII US BS EOT n1 n2 n3 n4
Hexadecimal 1F 08 04 n1 n2 n3 n4
Decimal 31 8 4 n1 n2 n3 n4
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Sets the port where the printer will look for raw tcpip communications.
LP Daemon
ASCII US BS ENQ n1
Hexadecimal 1F 08 05 n1
Decimal 31 8 5 n1
n1 = 0: disabled
n1 = 1: enabled
Default: disabled
Enables or disables the printer LP Daemon. The LP listens on port 515.
Telnet Daemon
ASCII US BS ACK n1
Hexadecimal 1F 08 06 n1
Decimal 31 8 6 n1
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Enables or disables the printer Telnet server. The Telnet server listens on port 23.
BootP
ASCII US BS BELL n1
Hexadecimal 1F 08 07 n1
Decimal 31 8 7 n1
n1 = 0: disabled
n1 = 1: enabled
Default: disabled
Enables or disables the use of BootP at power-up to obtain an IP address.
BootP is a subset of DHCP.
DHCP (auto-configuration)
ASCII US BS BS n1
Hexadecimal 1F 08 08 n1
Decimal 31 8 8 n1
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Enables or disables the use of DHCP at power-up to obtain an IP address. If no address is found
within two minutes, DHCP obtains the default IP address.