beautypg.com

Non-dcp switch applications, Cable, Figure 9-1 – AT&T AUDIX Networking 585-300-903 User Manual

Page 92

background image

9-2

DCP Cabling and Administration

________________________________________________________________________________________________

________________________________________________________________________________________________

________________________________________________________________________________________________

SWITCH

PORTS

DCP

ED-1E434-11

GROUP 300

CROSS-CONNECT

FIELD

(OR GROUP 500)

A

B

25-PAIR MALE

CONNECTOR

ACC (OR ACCE)

25-PAIR FEMALE

CONNECTOR

H600-331, GROUP 2

AUDIX NETWORKING

BREAKOUT CABLE

AUDIX

DCP

RS-232C

RS-232C

Figure 9-1. DCP Cabling to the Switch Using the H600-331, Group 2 Cable

Non-DCP Switch Applications

The AUDIX DCP channels are connected directly to the MERLIN II using D8W-87 modular cords. The
installation of the MERLIN II Communications System is the responsibility of the customer or AT&T
General Business Systems. Thus, the following procedure requires a coordinated effort between them and
the AUDIX system installer. Make sure that the TN366B, TN539, or TN539B board is installed in the
AUDIX system and that the AUDIX system and MERLIN II are operational.

1. Assemble the system modules as shown in Figure 9-2, MERLIN II Default Configuration and Slot

Assignments, and power-on the MERLIN II system. The numbering of the jack positions will be the
default numbering shown on the 008D modules in Figure 9-2. If additional 008D modules need to be
added for additional ports, the numbering scheme continues to increase upward from bottom to top,
left to right as shown.