AT&T AUDIX Networking 585-300-903 - Manual (Page 146)

11-28 DCP Mode 2 Installation and Administration
________________________________________________________________________________________________
________________________________________________________________________________________________ ________________________________________________________________________________________________
5. Using Procedure 100, Word 1, make the assignments shown in Fields 1 through 9 for the analog side
of the modem pool. Refer to Figure 11-13, Manager II Administration for Analog Side of Modem
Pooling (Proc 100, Word 1).
The trunk group (131) and the dial access code/trunk ID code shown are only examples; enter the
appropriate values supplied by the BCSDC.
ENHANCED MODE - PROCEDURE: 100, WORD: 1
TRUNK GROUP TRANSLATION
1. Trunk Group: 131
DIAL ACCESS CODE/TRUNK ID CODE
2. Digit 1: 2
3. Digit 2: 1
4. Digit 3: 5
5. Digit 4: -
6. Trunk Type: 101 Analog data modem pool (27)
7. Dial Access Restriction: 0 Access is allowed using DAC
8. Personal CO Line Appearance: 0 Not used for CO line appearance
9. Public Network Access/Egress: 0 Disabled
DISPLAY ONLY
10. Signaling Type: 27 Analog line loop
Connected to CC0 ON-LINE ♥ MAJOR MINOR RUN TAPE BUSY OUT IN USE WAIT
enter command: _
2 Repeat 3 Form 5 Help 6 Field 7 Input 8 Cmds
Figure 11-13. Manager II Administration for Analog Side of Modem Pooling (Proc 100, Word 1)