AT&T AUDIX Networking 585-300-903 User Manual
Page 102

9-12
DCP Cabling and Administration
________________________________________________________________________________________________
________________________________________________________________________________________________
________________________________________________________________________________________________
ENHANCED MODE - PROCEDURE: 014, WORD: 1
BEARER CAPABILITY CLASS OF SERVICE - CALL OPTIONS
1. Bearer Capability COS: 6
DEFAULT CAPABILITIES
2.
Transport Mode: 0
Circuit
14.
Transport Mode: 0 Circuit
3.
Information Type: 0
Restrict
15. Information Type: 0 Restricted
16. Bearer Capability: 4 Mode 0
CALL TYPES AND ACTION TAKEN
4.
Voice: 0 Circuit switch the call
5. Voice Grade Data: 1 Insert a mode 2-to-analog modem pool facility
6.
Mode 0: 0 Circuit switch the call
7.
Mode 1: 0 Circuit switch the call
8.
Mode 2: 0 Circuit switch the call
9.
Mode 3: 0 Circuit switch the call
10. Unknown Digital: 0 Circuit switch the call
11.
Unknown Analog: 1 Insert a mode 2-to-analog modem pool facility
12.
Mode 3/2: 0 Circuit switch the call
13.
X.25: 0 Circuit switch the call
Connected to CC0 ON-LINE
♥
MAJOR
MINOR
RUN TAPE
BUSY OUT
IN USE
WAIT
enter command: _
3 Data
5 Help
6 Field
7 Input
8 Cmds
Figure 9-6. Manager II Administration of DCP Port (Proc 014, Word 1)
3. The DCP extensions default to BCCOS 1. Change this to BCCOS 6 as shown in these examples.
This allows the DCP port to communicate with either a digital or analog outside facility.
A call to/from this port will be circuit switched unless it is voice-grade data or unknown analog. In
these cases, a modem pool will be inserted.